Balanced on a Point
"I have evidence to show the core masonry and the casing stones of the Great Pyramid at Gizeh
were positioned according to this triangle. It is not a right angle but approximately 89 deg. 56 min.
This accounts for its longevity, as the Great Pyramid was among the first built along the Nile valley.
Subsequent pyramids constructed by the plumb-bob method deteriorated over time, as earthquakes
loosened the stonework. The masonry stones of the Great Pyramid slope four minutes of degree,
down toward the centre. Built this way tremors tend to tighten the joints."
Joseph Edward Batter ...........1941 - 1994
"I have evidence to show the core masonry and the casing stones of the Great Pyramid at Gizeh
were positioned according to this triangle. It is not a right angle but approximately 89 deg. 56 min.
This accounts for its longevity, as the Great Pyramid was among the first built along the Nile valley.
Subsequent pyramids constructed by the plumb-bob method deteriorated over time, as earthquakes
loosened the stonework. The masonry stones of the Great Pyramid slope four minutes of degree,
down toward the centre. Built this way tremors tend to tighten the joints."
Joseph Edward Batter ...........1941 - 1994
"Triten Measure.....the Legend of Joey Bee", plots planetary mean distances on an expanding
golden ratio grid, with, lixcaliber, the "Mother of all Scales", found embedded, now emerging
from the heart of the Great Pyramid at Gizeh, through slope angle, number 5:
The Machine Array
Cross section of the Great Pyramid......scale 1 : 200
golden ratio grid, with, lixcaliber, the "Mother of all Scales", found embedded, now emerging
from the heart of the Great Pyramid at Gizeh, through slope angle, number 5:
The Machine Array
Cross section of the Great Pyramid......scale 1 : 200
From 1980 through 1993, design draughtsman, Joseph Edward Batter, and i, produced four scale
drawings based on the "pyrameter", a triangle Joe found within pi, phi, and the slope angle of quartz crystal,
marking the angle, between the base and the height of the pyramid, as slightly less than 90 degrees.
All the block courses slope nearly four minutes of degree, down towards the center.
phi, pi and the slope angle(s):
127.32200375 127.32395447
pyrameter triangle(s)
"The Machine Array", ( detail )
"Hi Phive" and "Point Phive" chambers
These are expansion drawings: ( x 5)
The pyramid centered inside the circle is 1/5th the pyramid containing the "Point Phive",
(queens), chamber, which is 1/5th the pyramid containing both of them, and everything else.
Of note here: the second expansion slope angle lines touch the point
where the chamber ceiling meets its vertical walls.
The pyramid centered inside the circle is 1/5th the pyramid containing the "Point Phive",
(queens), chamber, which is 1/5th the pyramid containing both of them, and everything else.
Of note here: the second expansion slope angle lines touch the point
where the chamber ceiling meets its vertical walls.
"Never chase after buses, wo\men, or cosmological theories.
There will always be another along in a few minutes" Isaac Asimov
The Astronomical Unit and the Soul of the English Foot
The AU, the mean distance from the Sun to the Earth, is the basis for measuring long distances
within the Solar System. Joe Batter suspected it was the source of a universal unit of measure.
At the time, he was plotting Planetary mean distance measurements from the 1979
Astronomical Ephemeris, with English feet, in tenths: 1/600.
He first converted the A.U. into feet.
The number is usually given now in meters: 1.4959787 x 10 to the 13th.
Converting to Feet by dividing meters by .3048 = 4.908066601 x 10 to the 11th.
Because Joe was working to a high degree of accuracy, a remarkable order of co-incidence
occurred within the Planetary mean distance numbers. When the pattern wouldn't gel,
i began to suspect the unit might not be the English Foot after all.
2 to the 5th x 5 x 33 = 5280
One of the exercises Joe performed with the A.U. in feet, was to multiply it by 33.
A.U. = ( 4.9080666 x 10 to the 11 ) x 33 = 1.619661978 x 10 to the 13th, feet.
He noticed the result is a close approximation of the Golden Section
and divided it by phi, 1.618033988, to produce the conversion ratio:
1.619661978 / 1.618033988 = 1.001006153
Conversely, dividing the Golden Section by 33 produces the AU, though not in feet:
490,313,329,924.21056006, or: 4.9031333 x 10 to the 11th, lix
Joe applied the "ancient" conversion to other known measurements such as
the remaining planetary mean distances, light speed, and the Great Pyramid at Gizeh.
The results confirm the existence of a base 10, inter-planetary system of measure,
founded in pi and phi.
31415 + 1618 = 33033
He named the System "TriTen", and the unit "lix".
1.001006(153) feet = 1 lix
" l ", is for light speed, " i ", is the planetary mean distance set, " x " is for time.
This introduction reveals some of the "phi nominal", rediscoveries we've made with them.
Walking you through TriTen is our next trek.
but first.....
"Circling the Squaring"
April 10, 2020
I've been inside lix geometry over four decades now, with related webpages produced, maintained
and upgraded continuously, since 1996. I knew the module: 73.728 lix, found in 2008, would
one day lead me out of the pyramid chambers and, in one day, it did.
Most of the focus these last number of years was assembling sister site, brainelevator.org;
merging the upper and middle chambers into one. Last week the work took a dramatic turn
when i realized three squared dimensions of the, "Hi Phive", (upper) chamber, the height, plus
the length, plus the ceiling diagonal, add up to the pyramid base perimeter.
First, the upper chamber ratios, dimensions and number code:
The AU, the mean distance from the Sun to the Earth, is the basis for measuring long distances
within the Solar System. Joe Batter suspected it was the source of a universal unit of measure.
At the time, he was plotting Planetary mean distance measurements from the 1979
Astronomical Ephemeris, with English feet, in tenths: 1/600.
He first converted the A.U. into feet.
The number is usually given now in meters: 1.4959787 x 10 to the 13th.
Converting to Feet by dividing meters by .3048 = 4.908066601 x 10 to the 11th.
Because Joe was working to a high degree of accuracy, a remarkable order of co-incidence
occurred within the Planetary mean distance numbers. When the pattern wouldn't gel,
i began to suspect the unit might not be the English Foot after all.
2 to the 5th x 5 x 33 = 5280
One of the exercises Joe performed with the A.U. in feet, was to multiply it by 33.
A.U. = ( 4.9080666 x 10 to the 11 ) x 33 = 1.619661978 x 10 to the 13th, feet.
He noticed the result is a close approximation of the Golden Section
and divided it by phi, 1.618033988, to produce the conversion ratio:
1.619661978 / 1.618033988 = 1.001006153
Conversely, dividing the Golden Section by 33 produces the AU, though not in feet:
490,313,329,924.21056006, or: 4.9031333 x 10 to the 11th, lix
Joe applied the "ancient" conversion to other known measurements such as
the remaining planetary mean distances, light speed, and the Great Pyramid at Gizeh.
The results confirm the existence of a base 10, inter-planetary system of measure,
founded in pi and phi.
31415 + 1618 = 33033
He named the System "TriTen", and the unit "lix".
1.001006(153) feet = 1 lix
" l ", is for light speed, " i ", is the planetary mean distance set, " x " is for time.
This introduction reveals some of the "phi nominal", rediscoveries we've made with them.
Walking you through TriTen is our next trek.
but first.....
"Circling the Squaring"
April 10, 2020
I've been inside lix geometry over four decades now, with related webpages produced, maintained
and upgraded continuously, since 1996. I knew the module: 73.728 lix, found in 2008, would
one day lead me out of the pyramid chambers and, in one day, it did.
Most of the focus these last number of years was assembling sister site, brainelevator.org;
merging the upper and middle chambers into one. Last week the work took a dramatic turn
when i realized three squared dimensions of the, "Hi Phive", (upper) chamber, the height, plus
the length, plus the ceiling diagonal, add up to the pyramid base perimeter.
First, the upper chamber ratios, dimensions and number code:
Yes, the "as built", dimensions of the chambers, within the Great Pyramid,
are square roots, to eight decimals of accuracy.
Join me, "outside the boxes", for a brief thousand pace stroll around
the most well known and least understood construction project on Earth:
Every square describes three circles.
The inner one touches the sides, the outer, the corners.
The ratio between these two is the square root of 2.
The third circumference, in between the two, is the sum of the four sides of the square.
The ratio between it and the diameter of the outer circle is the square root of 8.
2 to the 13th x .369 = 3022.848
Recently, following the Electric Universe evidence, and theories, at Thunderbolts, as well as the
remarkable plasma Sun experiments conducted at Safire, it occurred to me, the astonishing ratios
and exact dimensions circling the pyramid base, and height, may also be describing Hannes Alfvens
"double layers", and the cross section of a "Birkeland current", at extremely precise frequencies.
The geometry of a "Z-pinch".
Joe Batter was fascinated with a geometric model he called, "the basic shape of energy",
the "cone-cube". Six, 45 degree cones radiate from the centre to the six faces of a cube.
The volume of the cube, divided by the volume of the cones, is also pi / 4.
Joe's initial encounter with an application of the cone-cube, in the mid-seventies,
was the original spark that lit our way. All the way back here.
"something's afoot"
April 13, 2008
Our rediscoveries of the lix unit, the scale lixcaliber, planetary geometric centers, the
chamber dimensions, the modules, and a myriad of other wonders, are the results
of nearly two lifetimes of attention to detail and accuracy.
Much is owed to the master surveyors who marked the lines before our time.
A paper structure of equal volume could be built beside the Great Pyramid from all the speculative works
to reference its grande design. No esoteric meaning is ascribed here to basic ratios, so elegant, so profound,
so legible, any speculation or interpretation i might provide as an artist would be woefully inadequate,
as i am, by no measure, a mathematician, archaeologist, engineer or prehistorian to offer such context.
That being said, bairn of pi and phi, "lix", dimensions are eternal. Here, long before the first Myths were recorded. Here, well after the last ones are gone to dust. Embedded, in the "stone hearth of phive", resides the universal
scale, "lixcaliber", not as Arthurian weapon; tool for Passion, Division and War, but as Arthurian ideal,
instrument of Reason, Unity and Understanding.
In the face of resplendent measurement codes, ratios, and dimensions,
extensive reflection will achieve far greater insights than intensive conjecture ever has.
In another age people were inspired enough to strive together for a generation,
to dress and seal their knowledge of, "Earth Measure", inside a crystalline mountain:
481.101201415 lix high.
They clearly intended rediscovery. Whether by this era remains to be seen.
What happens to all the speculation, when the lid comes off?
An introduction to the, "lix coffer code", and its relationship to
the planetary positions on the lix grid, above, will be presented here next.
An introduction to the, "lix coffer code", and its relationship to
the planetary positions on the lix grid, above, will be presented here next.
Meanwhile, a "real world", application of lix geometry, an artifact, for your perusal,
rediscovered within the geometry of the Great Pyramid at Gizeh, in 2008:
rediscovered within the geometry of the Great Pyramid at Gizeh, in 2008:
